Using of high-speed mills for biomass disintegration
MetadataShow full item record
The need for mechanical disintegration of biomass is very current topic with regard to the requirements of an agrarian sector, beside the importance of a material’s moisture content reduction to be used in further applications. The drawbacks of commonly applied devices are the limited use of moist biomass and high energy consumption for disintegration. In collaboration with LAVARIS company, there were tested two high-speed mills LAV 400/1R with single rotor (used for a first milling) and LAV 300/2R with double rotors (used for a second milling), which were primarily designed for crushing of concrete, rubber and construction waste. The goal of the new technical solution was a disintegration of biomass on example of pine sawdust and miscanthus together with examination of simultaneous drying in order to achieve a desired fraction (particle size) and moisture content of biomass material. Experimental tests on highspeed mills have shown the following results: in case of pine sawdust about 98% of output particle size after passing through the first and second milling was smaller than 1.5 mm, and smaller than 1 mm for miscanthus (sieve analysis method was used for determination), i.e. significant reduction was achieved comparing to initial particle size. Moisture content of the materials after disintegration (first and second) decreased from 37.08% to 8.55% for pine sawdust and from 24.43% to 7.19% for miscanthus. Based on the results, it can be concluded that the mechanical disintegration of biomass by high-speed mills has a great potential to become an effective part of raw materials’ pre-treatment technology, not only in agriculture, but also in production of different types of biofuels.