Andmebaasi logo
 

Measurement of residual stresses in the cold-rolled Fe-Ni-Mn/Invar thermo-bimetallic plate

Lühendatud kirje lehekülg
dc.contributor.authorLille, Harri
dc.contributor.authorKõo, Jakub
dc.contributor.authorValgur, Jaak
dc.contributor.authorRyabchikov, Alexander
dc.contributor.authorReitsnik, Renno
dc.contributor.authorVeinthal, Renno
dc.date.accessioned2026-03-02T11:38:21Z
dc.date.available2026-03-02T11:38:21Z
dc.date.created2014
dc.date.issued2026
dc.description© (2014) Trans Tech Publications, Switzerlandeng
dc.description.abstractThe paper presents a method for measuring residual stresses in normal thermo-bimetal Fe-Ni-Mn/Invar strips with a thickness of 0.76 mm. For this purpose, a setup was designed which permits to remove layers from a strip substrate by electrochemical etching. Residual stresses in the directions that are longitudinal and transversal to rolling are determined by the curvature method based on the layer growing/removing techniques. As a reference, residual stresses were also determined by hole-drilling technique. Tensile and compressive residual stresses arose both in active and in passive layers and were considerably higher when determined by the hole-drilling technique.eng
dc.identifier.isbn9783038262305
dc.identifier.issn1662-9752
dc.identifier.publicationMaterials Science Forum Vols. 768-769 (2014) pp 101-106eng
dc.identifier.urihttp://hdl.handle.net/10492/10304
dc.publisherTrans Tech Publications Ltdeng
dc.relation.urihttps://doi.org/10.4028/www.scientific.net/MSF.768-769.101
dc.subjectthermo-bimetaleng
dc.subjectlayer removingeng
dc.subjectcurvature methodeng
dc.subjecthole-drilling techniqueeng
dc.subjectresidual stresseseng
dc.subjectarticleseng
dc.titleMeasurement of residual stresses in the cold-rolled Fe-Ni-Mn/Invar thermo-bimetallic plateeng
dc.typeArticleeng

Failid

Originaal pakett

Nüüd näidatakse 1 - 1 1
Pisipilt ei ole saadaval
Nimi:
Article preview 3.pdf
Suurus:
461.22 KB
Formaat:
Adobe Portable Document Format
Lae alla

Kollektsioonid

Jakub Kõo