Characterization of different wood species as potential feedstocks for gasification
MetadataShow full item record
This paper provides an extended overview of the chemical characteristics of 19 different wood species originating from Estonia. The variation of chemical composition in wood and bark was investigated using a variety of analytical techniques including WD-XRF, ICP-MS, and elemental analysis. Principal component analysis (PCA) was used to observe clustering in the sample set. It revealed a clear data clustering in terms of the wood and bark samples. Wood characteristics exhibit quite narrow ranges, on the other hand the composition of wood bark samples is significantly different and more distributed. The correlations and associations among 27 chemical parameters, including 16 ash-forming elements, were studied. Several significant positive correlations between Cr-Ni-Fe, Ca-Sr, Al-Na-Si-Ti, K-Mg-P, Fe-Zn-Cr-Ni-Cu, Ash-Ca, N-S-P and O-volatile matter were found. Most of the metallic components are negatively correlated with volatile matter, C, H, O and heating value and are positively related to each other, or no significant correlation was identified. Results are compared to literature data and technical quality standards for biomass. Biomass feedstocks availability and composition for gasification process was discussed. Wood samples had higher volatiles content than in bark which is an indication that higher conversion rate and lower gasification temperature can be used. Spruce, pine and black alder barks have higher fixed carbon content than other common species that may increase biochar yield. Commonly available woods like Scots pine, Norway spruce, aspen, birch, black alder and grey alder may considered as suitable feedstocks for gasification because of their low N, S, Cl, and ash content together with high volatile matter, however, relatively high total heavy metals content were found from birch and grey alder barks compared to other hardwoods.