Sirvi Autor "Kreicbergs, J." järgi
Nüüd näidatakse 1 - 3 3
Tulemused lehekülje kohta
Sorteerimisvalikud
Kirje Experimental analysis of hydrotreated vegetable oil (HVO) and commercial diesel fuel blend characteristics using modified CFR engine(2017) Gailis, M.; Rudzitis, J.; Kreicbergs, J.; Zalcmanis, G.Performance parameters of different commercial diesel fuels is a subject of interest for fuel consumers. Fuel retailer Neste recently introduced a new brand of WWFC 5th grade diesel fuel in Baltic market, consisting of diesel fuel and hydrotreated vegetable oil (HVO) blend. Fuel samples have been recently tested on chassis dynamometer, measuring wheel power and torque and in road conditions, measuring fuel consumption. Evaluation of fuel consumption and performance parameters in road or laboratory conditions may yield uncertain results due to complexity of modern automobile engine management and emission reduction systems. To better evaluate the combustion, fuel samples have been tested in modified CFR engine at various intake air pressure, temperature and compression ratio settings. Engine indicated performance parameters and combustion phasing of regular diesel fuel and diesel fuel-HVO blend are presented. Comparing to regular diesel fuel, fuel blend with HVO showed reduced apparent heat release rate (AHRR) during premixed combustion phase at low inlet air temperature and low compression ratio conditions, comparing to regular diesel fuel. Premixed combustion phase AHRR of diesel-HVO blend increased above AHRR of regular diesel fuel at higher inlet air temperature and higher compression ratio conditions. Diffusion controlled combustion phase AHRR of diesel-HVO blend increased above AHRR of regular diesel fuel at higher inlet air temperature, higher compression ratio conditions and supercharged air supply.Kirje Periodic polynomial regression analysis of urban driving characteristics(2019) Kreicbergs, J.; Grislis, A.Urban driving characteristics with a focus on energy consumption have been tested in Riga on three main city streets with inflexible coordinated traffic lights control. The aim of this article is to investigate periodic polynomial regression analysis method to analyse car urban driving parameters’ change during weekday twenty-four hours to assess the influence of vehicle technologies on energy consumption in city driving, to map the energy demand on Riga city main street sections and to evaluate the traffic lights control on flow energetic characteristics. The tests have been done using GPS and OBD data loggers on a test car repetitively driven along a preplanned route at around-the-clock hours. A regression analysis using periodic polynomials was developed and applied to evaluate the traffic flow characteristics with a given time shift. It was concluded that using polynomial regression function, the polynomial order has to be at least seven although a visual conformation of good regression line to the measured data has to be checked especially with lower orders. To evaluate the traffic conditions at a given 20 minutes to one hour shift the application of regression function is limited for the periods with fast changing traffic flow, especially after the end of rush hours when the usability of regression line for the given data has to be checked individually for tested street sections.Kirje Research on energy efficiency of pneumatic cylinder for pneumatic vehicle motor(2020) Gailis, M.; Rudzitis, J.; Madissoo, Marten; Kreicbergs, J.; Estonian University of Life Sciences. Institute of TechnologyCompressed gas is relatively expensive source of energy. When compressed gas is used for propelling of pneumatically driven vehicle, efficient gas utilization is favoured. Design and control strategy of pneumatic cylinder, with the emphasis on effective energy conversion is being discussed in this paper. Mathematical model, results of computer simulation and experimental work are provided and discussed. Experimental research is performed on the competition vehicle, equipped with pneumatically driven piston motor and instrumented. Relative significance of various geometric and control parameters of pneumatic cylinder on efficiency of energy conversion is presented.
